Shopping Cart
View Cart
Checkout
# of Item(s): 0
Total: $0.00

6 Tubes - J.T. Eaton 4 The Birds Bird Repellent Gel Item #666N 10z Bird Repeller

6 Tubes - J.T. Eaton 4 The Birds Bird Repellent Gel Item #666N 10z Bird Repeller

Manufacturer: N/A
SKU: N/A
Price: $68.99
This item is in stock

Quantity:



6 Tubes - J.T. Eaton 4 the Birds Bird Repellent Gel (Item #666N) 10oz

This listing is for 6 tubes of J.T. Eaton Bird Repellent Gel


This product may be used to discourage pigeons, starlings and other nuisance birds from roosting or perching on treated ledges, sills, roofs, peaks, cornices, and similar parts of municipal, industrial and commercial buildings, homes, apartment and condominium complexes,
bridges and overpasses and similar structures.


JT EATON 4 THE BIRDS® is a transparent, sticky product that remains tacky at 15° F and will not run at temperatures up to 200° F. Do not apply on location where desirable species of birds might become entangled in the repellent.

One 10 oz. tube of this product will treat 10 linear feet when product is applied in beads 1/2" wide and 1/2" high


Product Application: Use a caulking gun and/or a putty knife to apply this product. A properly applied bead of JT EATON 4 THE BIRDS® BIRD REPELLENT looks like this ^ in cross section. Press against surface to ensure good adhesion. To treat ledges or sills, apply beads of repellent no larger than 1/2" wide by 1/2" deep at the deepest part in strips no closer than 2" apart, beginning 1" in from the outer edge. To treat roofs, peaks, cornices, etc., apply a single bead of repellent along the highest point. A second treatment may be necessary if
product becomes flattened by heavy bird traffic.


Surface Preparation: Clean surfaces to be treated to promote adhesion of repellent. Wipe or scrape all dust, dirt, droppings, and other loose debris from surfaces. Seal porous surfaces prior to treatment by brushing on one coat of shellac or a 50% solution of white glue, and allow to dry.


One 10 oz. tube of this product will treat 10 linear feet when product is applied in beads 1/2" wide and 1/2" high


Partially Filled Cartridges: Replace cap on tip of tube.

Product Clean-up: Use mineral spirits to remove product from treated surfaces, equipment, or other contaminated articles.

Active Ingredient:

Polybutene 93%
Other 7%
Total 100%

Read the Label:


IMPORTANT NOTICE: Seller makes no warranty, expressed or implied, concerning the use of this product other than as indicated on the label. Buyer assumes all risk of use and/or handling of this material when such use and/or handling is contrary to label instructions.

It is a violation of Federal Law to use this product in a manner inconsistent with its label.


Be sure to add me to your !